"Savage" Tape Bracelet

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Remove the label from the bottle and cut off the rounded top of it.

• 

  Step 2

  Cut it down the middle, then cut a strip off the top of the bottle according to how wide you want your bracelet. Cut off the parts where the label stuck.

• 

  Step 3

  Get out the electrical tape and wrap, wrap, wrap.

• 

  Step 4

  Close the open end with another piece of tape

• 

  Step 5

  Start cutting out your letters. Whether you use construction paper or magazine is your choice, but i preferred the magazine because it looked rougher.

• 

  Step 6

  Start taping your letters on. If you used magazine letters, use pieces of tape wrapped in on themselves to stick them on.If you used construction paper, you can stick them on that way, too, or just put a piece of tape over the whole letter.

• 

  Step 7

  If you used magazine letters, put a small piece of clear tape over the letter.

• 

  Step 8

  If you used magazine letters, line in between the letters with electrical tape. Line the top and bottom, too. If you used contruction paper, cover the whole thing in clear tape. Try your best to smooth the air bubbles before you stick the tape all the way down.

  My band still had raw edges so i took more electrical tape and smoothed the edges down.

• 

  Step 9

  Done !
  There are still a few air bubbles in mine, but they got smoothed out after the picture .

  If you guys make one, post it so i can see (:

Versions

+ Add your version

Posted by

Emily M.

Comments

Leave your comment