Rocking Chair Cushion Cover

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  I started by drawing around the foam cushions I'd bought onto the back of the fabric. I did them about 1cm wider - just roughly drawn.

• 

  Step 2

  Hermann tried to help as I also cut a length of fabric long enugh to go aroun the edge. It was two inches wide to give room. I also cut out four strips measuring 16x2 inches.

• 

  Step 3

  Take the small strips, fold them in half lengthwise and sew down one small edge and the length. You'll have long thin tube left - turn this inside out

• 

  Step 4

  These are all my bits laid out

• 

  Step 5

  Sew the 16inch tubes, one onto each corner of the piece which will be the bottom of the cushion.

• 

  Step 6

  Take the longest piece of fabric and fold over the long edges so they meet in the middle.and iron them so the edges are creased.

• 

  Step 7

  Attach this long piece to the fabric that will be the top of the seat. Pin all around and then sew with a zig zag stitch.

• 

  Step 8

  This is the top piece sewn together with the long strip. The bottom piece is then attached to the other side of the long strip - I sewed 3/4 of the way around, turned the piece inside out and then hand stitched the remainder.

• 

  Step 9

  Voila! Thanks to those handy strips on the bottom, the cushion can now be tied on to the chair for secure butt warmth.

Comments

Leave your comment