Rick Rack Roses

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  · Cut a piece of jumbo-sized rick rack 36” long to make the finished flower shown here. I use vintage cotton rick rack because I prefer the soft, faded colors, but any type of rick rack can be used. If you want to dye the flowers you must use cotton or rayon rick rack with Procion or Dylon fiber-reactive dyes. The rick rack that’s available now is polyester, and cannot be dyed.

  · Fold the length of rick rack in half, and wrap one side around the other as shown at the top of the photo. The rick rack will nestle together. It may not lay perfectly smooth initially, but that’s okay. That curve will work to your benefit when you roll up the rick rack to form a nicely shaped rose.

  · Beginning at the end with the two raw edges, firmly roll up the length of rick rack to the end. Depending on how you cut the rick rack, you may have to trim the raw ends into a V in order to eliminate the raw edges peaking out of the center of the rose.

  · Tack the folded end down with a few stitches; then sew through the center of the rose near the bottom to hold the roll in place. I sew through the roll in an X shape, then go back and add another few stitches through it. A milliners needle will easily sew through the roll.

  · Turn the rose over, and gently fold back the last two rows of petals to complete your rose. Try experimenting with shorter pieces of rick rack to make small rosebuds. Obviously, 24” or 30” of medium-sized rick rack will make a smaller rose. If you have enough dexterity in your fingers, you can even make these roses with baby rick rack for tiny embellishments.

  Enjoy your beautiful flowers…

Comments

Leave your comment