Organza Ribbon Jewellery Set

  ✂︎

Favorite

Comment

List

       

Share

• Step 1

  Cut 2m of ribbon. Approximately 16cm along from the end tie a knot. Thread on a pink bead, push along to the
  knot and tie another to keep in place. Repeat alternating coloured beads until you have added 14 beads.

• Step 2

  Open a 7mm jump ring, loop over the central knot of your necklace, add another jump ring and close.

• Step 3

  Cut 20cm of ribbon, thread through the centre of the aluminium bead and tie into a knot. Trim the ends at an angle with a sharp pair of scissors. Open a jump ring, loop through the knot and attach to the jump ring at the
  centre of the necklace and close the jump ring.

• Step 4

  Cut the necklace to the desired length. Attach a ribbon clasp to each end. Add a jump ring to one end and
  a jump ring with a trigger clasp to the other.

• Step 5

  To make the bracelet.
  Cut two 40cm lengths of ribbon. Thread one length through the centre of the aluminium bead until it is halfway,
  tie a knot. Repeat on the other side. Add the beads and clasp in the same way as the necklace.

• 

  Step 6

  This is what your finished set should look like.

Comments

Leave your comment

Sarah D · La Cañada Flintridge, California, US · 31 projects 10th February 2011

Very pretty

Reply

emmilou w. · Wallasey, England, GB · 12 projects 26th May 2010

really love this, thanks for showing us how you made it... ^_^

Reply

Jolanda · Nederland, Colorado, US · 54 projects 25th May 2010

it's beautiful! nice done. x

Reply