About

Cost
$ $ $ $ $
Difficulty
• • • • •
Time
1h00

Bacause they said we couldn't go three deep....
Playing around with finger crochet. The first few steps are all learning to finger crochet/chain stitch/not sure what else it is called since I didn't find a tutorial for it on here, and the other steps are the execution of the bracelet

Posted by Asherah Arts (formerly Lee Rose) from St Joseph, Missouri, United States • Published See Asherah Arts (formerly Lee Rose)'s 19 projects »
PrintEmbed
  • Step 1

    First figuring out how much yarn you need or if you have enough:

    I wanted an 8 inch long bracelet, my finger crochet normally is about a 1:6 ratio (for every six inches of yarn I use I get one inch of chain) and since I was going to be finger crocheting it three times:
    8x6x6x6=1728 inches of yarn
    1728/12=144 feet of yarn
    144/3=48 yards of yarn

    But if you are too lazy, you can just leave the end of each open and add as you need it like I normally do.

  • How to make a chain bracelet. Funky Chunky Yarn Bracelet  (Also Known As The Inception Bracelet) - Step 2
    Step 2

    Next is learning to finger crochet: it is super simple, make a sliding loop knot at the end of your yarn (picture is after I've chained for a while but concept still stands) and stick your fingers through it,

  • How to make a chain bracelet. Funky Chunky Yarn Bracelet  (Also Known As The Inception Bracelet) - Step 3
    Step 3

    grab your yarn tail

  • How to make a chain bracelet. Funky Chunky Yarn Bracelet  (Also Known As The Inception Bracelet) - Step 4
    Step 4

    pull it through

  • How to make a chain bracelet. Funky Chunky Yarn Bracelet  (Also Known As The Inception Bracelet) - Step 5
    Step 5

    and tighten down the loop so that you have a new loop out of the old one. wash rinse and repeat over and over to make a chain. once you have chained all the yarn you calculated that you needed, or just gone as long as you'd liked, you can finish that chain by simply cutting the yarn or if you ran out just grabbing the end, sticking it through the last loop, and pulling so the loop tightens down on it but there isn't another loop to take its place

  • How to make a chain bracelet. Funky Chunky Yarn Bracelet  (Also Known As The Inception Bracelet) - Step 6
    Step 6

    NOW for the bracelet: once you've chained and finished your first level it is time to go for the next generation of chain. Make a sliding loop knot at the end of your chain, and begin to finger crochet chain your first finger crochet chain. Once you run out finish it in the same manner you finished the first chain.

  • How to make a chain bracelet. Funky Chunky Yarn Bracelet  (Also Known As The Inception Bracelet) - Step 7
    Step 7

    Once it has all been chained twice, take a step back, take a deep breath, and let out your best mad scientist laugh, because now we are going to chain crochet the piece we've already chain crocheted twice!

    Once you have run out of length you should be at the length you originally wanted. Finish the same as the other two. If you're feeling fancy you can add a clasp or something to close the bracelet, or you can do what i did and just run the raw yarn ends from each end through the other one and tie it.

    and now you have a super comfy, kinda sweatbandy, chunky, funky, inception bracelet. Feel free to customize by running ribbon or elastic through it, adding beads or charms, or whatever. it can handle it.

Made this project? Share your version »

Comments

Square 2019 12 15 221051 img 0513%2b2

More Projects