Dried Flower Charm

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Use a dry flower that contains very little to no moisture ( if it stil contains a lot of water ,then it will later rot)

• 

  Step 2

  Cut a piece of packing tape that is about 5 in long, or bigger depending of the size of your flower.

• 

  Step 3

  Lightly place your flower, face up, towards the end of your tape with some room to spare.

• 

  Step 4

  Carefully fold the tape over so that the bottom of the tape is directly over the top. Then start smoothly flatening the folded tape together, starting and the folded C side.

• 

  Step 5

  Carefully smooth out the tape so that there are no air bubbles trapped in the tape. It is ok if there is a thin air line around the flower its self.

• 

  Step 6

  Bubble cut around the flower, while leaving some room where you want the top of the charm to be.

• 

  Step 7

  Cut closer along the flower, but not to close, or ese the 2 pieces of tape will come apart. And again, leave room where you want the top of your charm to be.

• 

  Step 8

  Use a pin or a needle to poke a hole through the top blank piece of tape, where you left some space.

• 

  Step 9

  Take a jewlery hoop and connect it to the hole that you just made with a pin.

Comments

Leave your comment