Dragonglass Necklace

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Cut 2 pieces of wire.

  Wrapping the Arrowhead: Part 1

  • Place Wire 1 centred behind the arrowhead and bring both ends forward in an upwards V-shape
  • Twist together up to the top of the arrowhead

• 

  Step 2

  Flip the arrowhead over.

  Wrapping the Arrowhead: Part 2

  • Place Wire 2 centred behind the arrowhead and bring both ends together at the centre.
  • Twist once and then bend straight upwards, flat against the arrowhead

• Step 3

  Flip the arrowhead over again.

  Wrapping the Arrowhead: Part 3

  • Use Wire 1 to create a loop about 5mm above the top of the arrowhead. (I used a pencil to make the loop - I would recommend a smaller item as mine turned out far too big)
  • Leave approximately 5mm of wire after the loop and cut off the remainder.

• Step 4

  Flip the arrowhead over again.

  Wrapping the Arrowhead: Part 4

  • Separate the two ends of Wire 2
  • Cut the right end off at the length that it lines up with the Wire 1 loop
  • Use the left end to tightly wrap the 5mm lengths of wire up to the loop, then cut off the remainder.

• Step 5

  Attach a jump ring to the loop of the wire-wrapped arrowhead and thread a length of black cord through.

• 

  Step 6

  Finnish each end of the cord with a fold-over cord end.

  To one fold-over cord end, add a jump ring connected to a lobster clasp.

  To the other, add a jump ring connected to a short piece of chain.

Comments

Leave your comment