https://www.cutoutandkeep.net/projects/dragonglass-necklace • Posted by Jackkie
Be prepared for any white walkers that come your way.
Be prepared for any white walkers that come your way.
Cut 2 pieces of wire. Wrapping the Arrowhead: Part 1 • Place Wire 1 centred behind the arrowhead and bring both ends forward in an upwards V-shape • Twist together up to the top of the arrowhead
Flip the arrowhead over. Wrapping the Arrowhead: Part 2 • Place Wire 2 centred behind the arrowhead and bring both ends together at the centre. • Twist once and then bend straight upwards, flat against the arrowhead
Flip the arrowhead over again. Wrapping the Arrowhead: Part 3 • Use Wire 1 to create a loop about 5mm above the top of the arrowhead. (I used a pencil to make the loop - I would recommend a smaller item as mine turned out far too big) • Leave approximately 5mm of wire after the loop and cut off the remainder.
Flip the arrowhead over again. Wrapping the Arrowhead: Part 4 • Separate the two ends of Wire 2 • Cut the right end off at the length that it lines up with the Wire 1 loop • Use the left end to tightly wrap the 5mm lengths of wire up to the loop, then cut off the remainder.
Attach a jump ring to the loop of the wire-wrapped arrowhead and thread a length of black cord through.
Finnish each end of the cord with a fold-over cord end. To one fold-over cord end, add a jump ring connected to a lobster clasp. To the other, add a jump ring connected to a short piece of chain.