Dog Leash

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Pin decorative ribbon along center of webbing and edge stitch it into place along either edge.

• 

  Step 2

  To make handle, fold one end over by 6 in with ribbon side out, and tuck a 1 inch section back under this fold. Stitch through all 3 layers at the fold and through two layers just above the folded-under edge, to enclose cut edge. Reinforce seams with an “X” if desired.

• 

  Step 3

  With ribbon side facing out, slip the other end of webbing through D-Ring. Fold over 2 in and topstitch a seam next to D-Ring. Fold remaining raw edge back under and stitch through 3 layers enclosing rough edges. Reinforce seams if desired.

• 

  Step 4

  The collar is already built in with this type of trainer style dog lead: pull a length of leash through D-Ring to create a loop then slip over your dog’s head. If you prefer a more traditional leash, substitute a snap hook for the D-ring. These are usually available at your local hardware store.

Comments

Leave your comment