Dainty Adjustable Bracelets

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  This DIY requires very few materials. All you'll need is some scissors, embroidery thread, beads and a few pieces of tape.

• 

  Step 2

  Measure out your embroidery thread by wrapping it around your hand/knuckles while it's in a fist. Add about six extra inches.

• 

  Step 3

  String your beads onto your thread and make knots on either side of the design so the beads don't slide around.

• 

  Step 4

  Place your bracelet flat down. Take one side and bring it up to the other side, as pictured.

• 

  Step 5

  Repeat step 4 with the other side of your string. Put pieces of tape down on either side of the bracelet.

• 

  Step 6

  Cut about a 6 inch piece of string and place it underneath the two pieces of string that make the bottom of the bracelet.

• 

  Step 7

  Now you have to do a square knot, about 5/6 square knots in all. If you're unsure of how to do a square knot, you can watch my video tutorial of this project to see a quick tutorial of the square knot: https://youtu.be/dYoMkVZcZt8

• 

  Step 8

  Cut the excess off and put some nail polish on either end to keep it in place.

• 

  Step 9

  Place your bracelet on your hand to make sure it fits over the largest part of your hand. Slip it off.

• 

  Step 10

  Trim the ends and put little beads and knots on the edges. When you pull the strings, your bracelet will be easily adjustable.

• 

  Step 11

  Enjoy your finished bracelet and be sure to make some for friends and family since they are so easy and simple to create!

Comments

Leave your comment