https://www.cutoutandkeep.net/projects/dainty-adjustable-bracelets • Posted by Mademoiselle Ruta
Dainty bracelets have been in for quite some time now, and these are super quick and simple to make!
Dainty bracelets have been in for quite some time now, and these are super quick and simple to make!
This DIY requires very few materials. All you'll need is some scissors, embroidery thread, beads and a few pieces of tape.
Measure out your embroidery thread by wrapping it around your hand/knuckles while it's in a fist. Add about six extra inches.
String your beads onto your thread and make knots on either side of the design so the beads don't slide around.
Place your bracelet flat down. Take one side and bring it up to the other side, as pictured.
Repeat step 4 with the other side of your string. Put pieces of tape down on either side of the bracelet.
Cut about a 6 inch piece of string and place it underneath the two pieces of string that make the bottom of the bracelet.
Now you have to do a square knot, about 5/6 square knots in all. If you're unsure of how to do a square knot, you can watch my video tutorial of this project to see a quick tutorial of the square knot: https://youtu.be/dYoMkVZcZt8
Cut the excess off and put some nail polish on either end to keep it in place.
Place your bracelet on your hand to make sure it fits over the largest part of your hand. Slip it off.
Trim the ends and put little beads and knots on the edges. When you pull the strings, your bracelet will be easily adjustable.
Enjoy your finished bracelet and be sure to make some for friends and family since they are so easy and simple to create!