About

Cost
$ $ $ $ $
Difficulty
• • • • •
Time
3h00

The littlest Maiden!
This is my 3rd figure carving, and since I'm such an old hand at it now (LOL yeah right) I decided to not only do a much more difficult pose this time but also make it from the tiny scrap of wood I had left over from the Mother figures. So yeah, this was 'fun' to make...

Actually, considering she's only 1 3/4" high, she went really well. I am frankly amazed I managed to get her looking anywhere near as good as this :) There are flaws, bits I'd do differently if I was mentally abberant enough to try tiny figure carving again, but all in all I'm really pleased with her. Looking forward to getting some more wood so I can try some more poses

Posted by Raven W. from Brisbane, Queensland, Australia • Published See Raven W.'s 56 projects »
PrintEmbed

Raven W. posted this project as a creation without steps

Here are some similar tutorials to help you make this one!

Made this project? Share your version »

Comments

Lidia P.
Lidia P. · Charlotte, North Carolina, US · 2 projects
What kind of wood did you use? And where would be a good place to buy some?
Reply

More Projects