Batman Wrist Pin Cushion

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  First you'll need to trace around the oval stencil. I left about a 1/2 inch seam allowance. Cut 2 ovals.

• 

  Step 2

  Now measure around the outside edge of the oval.

• 

  Step 3

  Add one inch to the above measurement, and make the width of the strip 2 inches. Cut this strip out. This will be the outside edge of the cushion. (My felt was too short to cut one continuous strip, so I divided my measurement in two and cut two strips.)

• 

  Step 4

  Trace one of the felt ovals onto the coffee lid. Cut.

• 

  Step 5

  Trace the Batman symbol onto the black felt. Cut it out.

• 

  Step 6

  Measure your wrist. Add two inches to the circumference measurement, and make the width 2 inches. Cut two of these. This will be your wrist cuff.

• 

  Step 7

  Pin the Batman symbol to one of the ovals, and stitch it down.

• 

  Step 8

  Pin the two wrist cuff pieces together, and edge stitch them together.

• 

  Step 9

  Stitch Velcro to the wrist cuff as pictured above.

• 

  Step 10

  Pin the non-Batman symbol oval to the outside edge piece. Stitch.

• 

  Step 11

  Pin the Batman symbol oval to the piece you just stitched, leaving an opening large enough to slip the plastic oval into the cushion. Stitch. Turn the cushion right side out.

• 

  Step 12

  Slip the plastic oval into the cushion. You may have to trim it down a bit to get it to fit properly inside.

• 

  Step 13

  Now stuff the cushion! Make sure it's firm.

• 

  Step 14

  Slip stitch the opening closed.

• 

  Step 15

  Use a hot glue gun to glue the pin cushion to the wrist cuff. And ta da! You're done!

Comments

Leave your comment