Shamballa Style Bracelet With The Beadalon Tying Station

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Cut one piece of Beadalon Bead Stringing Wire 14 inches long and one piece of Wire about 5 1/2 feet long.

• 

  Step 2

  String one size 2 Crimp Tube on the short Wire. Make a loop big enough to fit over your button clasp and crimp it in place.

• 

  Step 3

  Snip the short end and cover the crimp with a crimp cover.

• 

  Step 4

  Secure the loop to the top of the Acrylic Tying Station.

• 

  Step 5

  String the 8 beads onto the beading wire. Secure the Wire to the bottom of the Acrylic Tying Station.

• 

  Step 6

  Take the long wire and center it underneath the secured down wire. Tie an overhand knot to secure the wire.

• 

  Step 7

  Tie a knot by taking the right side of the long wire over the short wire and under your left wire. Take the left wire and feed it under the short wire and up through the loop on the right hand side.

• 

  Step 8

  Repeat Step 7 [12 times] then push up the first bead.

• 

  Step 9

  Tie another 12 knots under your bead by following step 7 again. Push up another bead.

• 

  Step 10

  Continue tying knots and pushing up beads until you reach the end of your bracelet, ending with 12 knots. (You may have to add another bead, or adjust your knot count to fit your wrist.)

• 

  Step 11

  String a size 3 crimp tube onto the end of the short wire and feed the long wires through as well. Crimp the crimp tube, cut off the 2 long wires, but leave the short wire.

• 

  Step 12

  Attach the button by stringing a size 2 crimp tube and the button. Go back through the crimp tube and crimp.

• Step 13

  Cover crimp tubes with crimp covers.

• Step 14

  Tip: 12 knots between each bead makes a 7” bracelet. 14 knots between each bead makes an 8.5” bracelet.

Comments

Leave your comment