Sunglasses Pouch

  ✂︎

Favorite

Comment

List

       

Share

• Step 1

  First take a look at the pattern with measurements I made and check the pictures

• Step 2

  Cut 2x A out of the black faux leather

• Step 3

  Pin the A pieces good sides facing

• Step 4

  Now sew all sides, except 3/4 of the smaller left side and cut away extra fabric. Turn the piece -good side out- (take a pen to help the corners) and put it aside

• Step 5

  Cut B out of the orange faux leather

• Step 6

  Cut C,D,E, F and G out of the sturdy fabric and sew the edges as described in the measurement instructions

• 

  Step 7

  Pin D onto C, align the right sides of the pieces and good side facing you

• Step 8

  Now sew the right side of CD

• 

  Step 9

  Pin CD onto the right side of B. Align the top and sew the top of CD on B. The right side and bottom of CD will be a bit bigger then B (that is ok)

• 

  Step 10

  Take F and E and pin and sew the right side of F on the right, bottom side of E

• 

  Step 11

  Now make folds in F (lengthwise) on 2 cm of the edges so it will become a pocket

• 

  Step 12

  Pin F onto E, the folds should make F as wide as E

• Step 13

  Sew the bottom (about 8 cm from top of F) of FE

• 

  Step 14

  Sunglass Pouch DIY
  14. Take one side of the Velcro and sew it on F, top middle

• 

  Step 15

  Now you can also sew the left side of F on E

• Step 16

  Take G, this is the flap (make sure it is fits the pocket you just made, about 8.5 cm wide, after seaming), and sew the other side of the Velcro on the back bottom of G, in the middle

• Step 17

  Pin G on E, above the pocket (F) so the Velcro pieces fit perfectly

• Step 18

  Now sew the top of G on E

• 

  Step 19

  Take EFG and pin and sew the top of EFG on B, about 2 cm left from CD. I sewed it 2 cm under the top, so the orange fabric is still visible (check the picture)

• 

  Step 20

  BCDEFG is ready to be attached to the A pieces you made earlier

• Step 21

  Place the good side of BCDEFG on A (A has two good sides) and pin the left, right and bottom side in a way the top is about 1.5 cm below the top of A (top is were both sides of A are sewn)

• Step 22

  Now sew, carefully, close to the edge

• Step 23

  Cut away some excess fabric close to the seam and turn it good side out

• Step 24

  Decide where the press button should come and sew it, with a whip stitch on the inside of B and A

• 

  Step 25

  Go and shine!!

Comments

Leave your comment

Steph. · Reading, England, GB · 212 projects 26th December 2014

clever!

I Love Green Grass · Heidelberg, Baden-Württemberg, DE · 28 projects 27th December 2014

Thanks

Reply