Pastel Flower Bracelet

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Use the memory wire shears to cut five pieces of memory wire. Each one should be one full coil plus 1" (2.5cm).

• 

  Step 2

  Turn an inward loop on one end of each coil. String 3 turquoise beads.

• 

  Step 3

  String the outside hole of a spacer bar onto the memory wire.

• 

  Step 4

  String fifteen turquoise rondelles.

• 

  Step 5

  Insert the wire through the outside hole of a second spacer bar.

• 

  Step 6

  String six turquoise rondelles.

• 

  Step 7

  Insert the memory wire through the outside hole of the flower slider.

• 

  Step 8

  String six turquoise rondelles, then thread the wire through the outside hole of a third spacer bar.

• 

  Step 9

  String fifteen turquoise rondelles and the outside hole of the fourth spacer bar.

• 

  Step 10

  String three more rondelles.

• 

  Step 11

  Move all the beads along the memory wire to remove any excess space but don't make them too tight on the wire. Trim the wire to 7/16" (11mm) with the memory wire shears.

• 

  Step 12

  Turn an inward facing loop.

• 

  Step 13

  Take a second piece of memory wire. String three aqua beads and then pass the memory wire through the second hole of the spacer bar. Continue stringing aqua beads following the same pattern as the turquoise beads. Pass the memory wire through the same loop of the flower as the turquoise beads. You may need to adjust the number of beads used on either side of the flower to make the slider sit nicely. Finish stringing the aqua beads and then turn an inward loop.

  String the pink, salmon and apricot beads in the same way with the following variations:

  Pink row: thread the wire through the middle hole of the flower slider.

  Salmon and Apricot Rows: thread the wires through the remaining outside loop of the flower slider. You may need to adjust the number of beads to make the flower sit properly.

• 

  Step 14

  To thread the apricot row of memory wire through the flower slider, you will need to use pliers to draw it through.

• 

  Step 15

  Use pliers to feed the wire through the top hole of the spacer bar. If necessary, bend the end of the memory wire down a little to help you feed it through. Finish stringing the beads and turn an inward loop to complete your bracelet.

Comments

Leave your comment