About
Spooky spirit board necklace!
Easy to make this ouija board necklace...make it as big as you like.
This one is 1 inch x 1.5 inches and I attached it to a chunky black chain.
Use the same technique for any other picture if ouija boards are not your thing.....
Tags
-
Kinhime Dragon favorited Ouija Board Necklace
11 Apr 18:04
-
Tashianna S. favorited Ouija Board Necklace
11 Apr 12:29
-
niattirb.strawn favorited Ouija Board Necklace
05 Dec 05:59
-
Key West Witch added Ouija Board Necklace to Ouija
21 Mar 01:12
-
Kel M. added Ouija Board Necklace to Accessories
09 Aug 12:24
-
Holly S. favorited Ouija Board Necklace
10 Jul 23:19
-
Stephanie B. favorited Ouija Board Necklace
24 Sep 11:05
-
Jennifer V. favorited Ouija Board Necklace
21 Jun 13:24
-
Francine S. favorited Ouija Board Necklace
17 Jun 23:22
-
mmotse03 favorited Ouija Board Necklace
09 Sep 08:07
-
Step 1First, print out a picture of the ouija board, and glue onto thick card.
Give a light spray of Humbrol "just spray" acrylic varnish, or similar, to protect the surface.
Cut round shape with a sharp craft knife. -
Step 2Roll out some black polymer clay to about 3mm ( one eighth inch) thick, make it larger than the ouija board picture.
Place on an old glass plate or flat ceramic tile....this will be going into the oven! -
Step 3Place ouija board on top and press gently into clay....press evenly with a flat surface like the bottom of a glass, to avoid bending the picture.
-
Step 4Trim all round leaving approx. 3mm border
-
Step 5Bend the border of clay up around the picture...no tools required, just smooth with your fingers!
-
Step 6Next take two pieces of black wire, each 1 long...I didn't have any black wire left, so I cut a black headpin in half!
Bend into loop shape as shown.
Do this with the clay/picture still placed flat on the plate or tile. -
Step 7Insert the loops into the clay just below the picture board, one at eack top corner...these will be used to attach the chain.
Using little scraps of clay, fill in holes around wire, pressing and smoothing the clay with a toothpick -
Step 8When the holes are filled in and smoothed, put in oven at 130degrees C for 30 minutes...take care not to make any hotter or the picture will scorch.
Bake on the plate or tile you have formed it on, because if you try to lift it off, it will get all out of shape!
When cool, gently prise away from the tile with a craft knife or similar. -
Step 9Cut two pieces black chain 7" each.Attach to loops and fit on black toggle clasp....you can use ant other type of fastening you have, but I use these for easiness!
-
Step 10You can give your necklace another coat of varnish, if you like.
That's it, ready to wear!
1
Stud Earrings »
Miraculous Ladybug Earrings
I'll be making this for my next show!!
Thankyou for the amazing idea xxxx