Great Embellishments

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  To make a ribbon flower, thread a
  4mm pearl onto a headpin. Cut 25cm
  of ribbon, fold one end of the ribbon
  in by 1cm. Push the headpin through
  the ribbon so that the fold is on the
  opposite side to the bead. Weave the
  headpin through the ribbon at
  approximately 1cm intervals.

• 

  Step 2

  Push the ribbon along the
  headpin towards the bead as tightly
  as possible. Trim the headpin 1cm
  along from the ribbon, bend into a
  loop and close. This will act as a
  stopper for the ribbon. Repeat to
  make ten more flowers.

• 

  Step 3

  Cut 45cm of chain. Attach a
  flower to the centre of the chain by
  opening the left hand side of a
  connector with your pliers, close the
  connector. Work out from the centre
  adding a flower to each connector
  until you have added the remaining
  flowers in the same way.

• 

  Step 4

  . Thread a 4mm bead onto a
  headpin. Trim 1cm above the
  bead bend into a loop, attach a
  heart connector and close the
  loop. Add an eyepin to the heart
  connector, thread on a 6mm
  bead. Trim the eyepin 1cm
  above the bead, bend into a
  loop making sure the loop is in
  the same direction as the eye of
  the eyepin, add a second heart
  and close the loop.

• 

  Step 5

  Use a 5mm jump ring to attach the
  beaded section to the centre link of the
  chain. Repeat to add a beaded section to
  each link with a ribbon flower. Add just a
  4mm bead on a headpin and a heart
  connector to each of the links at the ends
  of the ribbon flower section.

• 

  Step 6

  Use a 5mm jump ring to attach a
  trigger clasp to one end of the chain.

Comments

Leave your comment