About

Cost
$ $ $ $ $
Difficulty
• • • • •
Time
1h00

Simple ball chain turns into eye catching arm candy.
This is a very simple way to make one of these without spending a lot. This project is not based on how you make it but how you wear it, because when you take it off it will be back to a large ball chain.
Also I warped it around my wrist three times so i can have two bands on my wrist, but you can most certainly do it twice and just have one band on your wrist. I got this ideas form looking at a Finger Chain Hand Harness on Asos.com it was too much for me to buy it so I made this one.
To make this even better I stacked my other bracelets with it.

Posted by Neha M. Published See Neha M.'s 2 projects »
PrintEmbed
  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 1
    Step 1

    Materials:
    1. Wire cutters, or scissors.
    2. Ball chain
    3. Ball chain end.

  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 2
    Step 2

    Take the ball chain and wrap it around your wrist three times,and make sure it is a little lose.

    Then take your scissors or wire cutters and cut the ball chain where needed.

  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 3
    Step 3

    Now take the two ends of the ball chain and clasp them together with a ball chain end.

    You should have a large ball chain now that fits loosely around our wrist three times.

  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 4
    Step 4

    Now take the chain and wrap it around your wrist twice.

  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 5
    Step 5

    Take the lose end and twist it so it should look something like this...

    leave a loop at the top so your finger can slide into it. *leave it loose enough so that you can slide it onto your finger but tight enough so that the twisted part doesn't look loose.

  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 6
    Step 6

    How you put it on.
    Place the loop between your first and middle fingers.
    Should look like this.

  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 7
    Step 7

    Then slide your middle finger through the loop

  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 8
    Step 8

    and pull through and slide in place.
    * Note that if it is too loose it will not look right and if its too tight you might break the chain (which I did earlier).

  • How to make a hand bracelet. Finger Chain Hand Harness.  - Step 9
    Step 9

    Finished :).
    oh I almost forgot. To take it off all you have to do is take one side of the ball chain clasp end off and it will come right off. Do not try to take the chain off your finger it will not come off. (I've tried.)

Made this project? Share your version »

Comments

More Projects