Easy To Make Bracelets Out Of Chunky Chain

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Elements in the modern jewelry:

  Wooden Bead

  Chain

  Organza Ribbon (6mm)

  0.5mm Brass Wire

  Flat Nose Plier

  Round Nose Pliers

  Side Cutting Pliers

• 

  Step 2

  Step 1: Design the skeleton of bracelet

  1. Measure a strand of chunky chain around your wrist, usually 13~15cm is enough. Snip it into 2 equal parts.

  2. Take a 30cm wire. Thread through the first link on chain and then the loop it. Reserve a little space to allow the ribbons to pass through.

  3. Slide on the focal wooden bead.

  4. Connect the other chain strip in same way. Cut off any excess wire.

• 

  Step 3

  Step 2: Braid the ribbon strands

  1. Gather the start of the 3 ribbon strands (50cm for each) with short wire. That may help the ribbon go through chain links more rapidly.

• 

  Step 4

  2. Thread the ribbon through the connective wire loop first. Pull the tip and stop at the center location.

  3. Take the left end over the right one. Continually use the top left end to go through the first link upwards.

  4. Over the left end and over the right one, and then direct the left one through the next link from back to front.

  5. Keep braiding like this for all links.

  6. At the end, hold the two ends together with a knot.

• 

  Step 5

  7. Repeat all steps above for the other chain.

• 

  Step 6

  Step 3: Wear your bracelet

  Just take the bracelet and tie it to your wrist.

  There your first modern jewelry has been whipped up successfully. However, finding one piece that flatters your appearance, demonstrates your style, and coordinates with your wardrobe can be actually difficult unless you make it yourself. Just enjoy yourself while practicing these easy to make bracelets.

Comments

Leave your comment