Diy Vintage Children's Book Note Books

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Cut up book and punch holes- carefully cut up the spine of your book with scissors and carefully remove the pages from the spine, then trim the spine off so you have an even front and back cover. Then measure and mark your spacing for your holes in your book. I made a little template on scrap paper. I measured up from the end one inch at the top and bottom, and then one middle hole that was in the middle of the first two holes. Punch out the marks to make your template then mark holes on covers. Then punch your covers where you marked for the holes. I used my cropadile with the 3/16ths hole.

• 

  Step 2

  Cut Paper- Measure the width and height of your covers. You want your pages to be about a quarter-inch smaller than the covers. Using your paper-cutter cut your inside pages of copy paper, scrap paper,etc to size. For example if your book is 4.25×6.25, cut your pages to be 4×6. I’m not sure how many pages I ended up with, probably about 100 or so.

• 

  Step 3

  Punch Holes- Using the template you made earlier measure and punch holes in all your pieces of paper. This takes a while, but goes pretty fast if you get a buddy to help. Be careful not to get sloppy or your holes won’t match up later.

• 

  Step 4

  Assemble- Open up your binder rings and load your back cover onto the three rings. Then slowly add little stacks of pages until you have all your inside pages on rings. Add the front cover and close rings. And you are done! Pretty cool huh!

Comments

Leave your comment

CreativeGirl79 · Nanaimo, British Columbia, CA · 4 projects 16th December 2014

Neat Idea! Love it!

Reply