Diy Rope Bracelets

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Step 1: Create the focal knot

  1. Prepare two strips of cord, each about 50cm long. Wrap the tips with tape so that they don’t fray away while making the knot;

  2. Fold one cord in half. Make a loop where the cords overlap each other as shown in the picture;

  3. Also fold the 2nd cord, however, insert it under the loop;

  4. Take the folded tip of the 2nd cord and pass under the tails of the loop;

  5. Still working with the folded part, thread it through the loop from left to right over-under-over;

  6. Tighten the knot slightly. Pay attention to how you work with the cords, trying to keep them flat for a better looking and even rope bracelet pattern.

• 

  Step 2

  Step 2: Cut off the excess parts

  Measure the length that you desire for the bracelet. Then, place a piece of tape all the way around the four strands where you will make the cut.

• 

  Step 3

  Step 3: Add on the clasp

  1. Remove the excess cords and then dab drops of glue to the cut ends;

  2. After the glue has completely dried, attach a wide ribbon end. Squeeze tightly;

• 

  Step 4

  3. Repeat the same process on the other side;

  4. Add on the clasp and tag connector by using two jumprings.

• 

  Step 5

  Congratulations!

Comments

Leave your comment

Huma I. · 1 project 16th July 2013

Great how to! definitely gonna try this

Sophia K. · 134 projects 17th July 2013

I'm glad that you like it.

Reply

CazSteele · Cape Town, Western Cape, ZA · 8 projects 9th July 2013

Thanks for this lovely How-to! Love the blue colour. <3

Sophia K. · 134 projects 10th July 2013

Thanks for your comment, the blue color is pretty!

Reply