Diy Button And Cord Bracelet With Charms

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Measure and cut your cording to approximately 54 inches in length ~ fold in half and then half again so that you have four rows.

• 

  Step 2

  Insert your cording evenly into your button ~ through 4-holes, 2-holes or all four through the shank.

• 

  Step 3

  Make sure that the button is evenly placed but if it isn’t as long as it is close to being centered you’re all good! {you can always even out the ends later}

• 

  Step 4

  Next, place a charm on 2 of the rows of cording anywhere you desire ~ this will all depend on how many charms you are using as you will want them to be evenly placed throughout the brace.

• 

  Step 5

  Now tie a knot using all four cords of the bracelet.

• 

  Step 6

  Continue adding charms and tying knots ~when you are all done adding your charms tie a knot at the very end and cut it off evenly. {I also added a knot at my button end at this point to secure things up a bit.}

Comments

Leave your comment