Dainty Layered Necklaces Diy!

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Gather your materials. You'll also need round-nose pliers, flat-nose pliers and cutters. (not pictured)

• 

  Step 2

  At first, cut 3 pieces of chain. Measure each piece approximately on your neck to decide it's length and we'll get back to that at the end.

• 

  Step 3

  For the first necklace, the short one, take your eyepin and thread the beads and the teardrop in the middle. Make a loop at the other side, connect it with the chain and close the loop. Open the other loop and connect it with the other side of the chain.

• 

  Step 4

  Bend the headpin a little in the middle and set it aside.

• 

  Step 5

  Let's make the one with the agate. Using jumprings and your pliers, connect each side of the connector with each side of a piece of chain. Set it aside. (We will put clasps at the end).

• 

  Step 6

  Move on to make the long pendant necklace (love, love,love this pendant!). This is the easiest one. Using a jumpring connect it to the chain.

• 

  Step 7

  Finally take all 3 necklaces, arrange them on your neck the way you like and cut the chains where needed. Now connect the lobster clasps with jumprings and you 're done!

• 

  Step 8

  Wear them all at once, or each one on it's own, or 2 at once...well you get the picture! I hope you enjoy making them and also wearing them! (I know I did!)

Comments

Leave your comment