Bustling Flower Watch

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Measure your watch face and cut your chain to make
  your bracelet up to a total length of 8” (larger or
  smaller if required)

• 

  Step 2

  Cut your chain in half and add a clasp part to each
  piece.

• 

  Step 3

  Onto a headpin thread a small seed bead followed by
  a 6mm bead and a flower cap to sit on top of the bead.

• 

  Step 4

  Bend the pin (do not cut any wire off at this stage) and
  loop onto one of the links on your chain.

• 

  Step 5

  Form the wire around into a loop enclosing the link,
  and wrap the wire round the head of the flower cup
  twice.
  Nip off the wire close to the cup and make sure it is
  tucked in neat so no sharp bits protrude.

• 

  Step 6

  Add TWO flower pins to EACH link, fill up both lengths
  of chain as shown in the pic.

• 

  Step 7

  Open the link on the watch face and add the flower
  chain.
  Repeat for the other side.
  You may like to add a couple of flower pins to the
  actual watch link too to add more fullness.

• 

  Step 8

  Wear with pride !

Comments

Leave your comment