Brass And Leather Charm Bracelet

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Supplies needed for making this bracelet.
  Decorative link
  Black leather cord
  Artistic wire
  5 small jump-rings
  1 large jump-ring
  Charms & Beads
  Lobster clasp
  Chain
  Two bent-nose pliers
  Round-nose pliers
  Flush wire cutters

• 

  Step 2

  Cut a piece of leather cord about 16” long, then string the lobster clasp onto the cord.

• 

  Step 3

  Center the clasp then tie a knot in the cord to hold the clasp in place.

• 

  Step 4

  Add your jump-rings to your decorative link, I added two small to one side to run my cord through for added strength. The larger jump-ring is part of my clasp (hook the lobster clasp onto).

• 

  Step 5

  Now run your cord through the smaller jump-rings, fold ends over, (adjust the length for your bracelet here). This bracelet measures 7” in total length.

• 

  Step 6

  Cut about a 3” piece of artistic wire for wrapping around the cord to secure.

• 

  Step 7

  Fold the ends over and start wrapping the wire around your leather cord tightly to secure.

• 

  Step 8

  Tuck wire end under using your bent-nose pliers, and trim the excess cord.

• 

  Step 9

  Add your charms.

• 

  Step 10

  Add as many charms, or wire wrapped bead charms as you like.

• 

  Step 11

  The chain was an after thought, so if you would like to add some chain just use a piece of chain the same link as your cord, connect it to the Jumprings at each end.

Comments

Leave your comment