Bling Holder

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Gather up all you materials and
  earrings

  *trace the back card of your frame onto blank paper. Mark and measure out all of your bling. As bling comes in a vairety of shapes & sizes

  *score all of the markings on to the back part of the frame

• Step 2

  *place the back board of frame onto a piece of foam, thick card or wood board. Then lay onto a hard surface (whoops don't mark the the wooden floors or table) and hammer through all of the pre marked spots for your earrings

  *spary the front of the board with glue and place your fabric or paper on the board. press flat with your hand, pressing out all the creases. let dry & cut off excess. I used pain paper for effect

• 

  Step 3

  *take the nail and push through all the holes. Front to back for a neater result. Then place board back in frame. A little craft clue on the corners to hold into place

  *stick on some bling and stick in your bling and there you go =) little basic & temporary for now, but you get the idear. Oppshopp hunting now for that massive frame for the rest =)

  yay for recycling & fancy!
  happy crafting =)

Versions

+ Add your version

Posted by

delilah b.

Comments

Leave your comment