Quilled Teapot

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Take Strips of length 21.1 cm and width 5 mm.

• 

  Step 2

  For teapot:

  Take 8 strips & join them. Then roll it on pen to get ring shape.

• 

  Step 3

  Make thick ring coil.

• 

  Step 4

  Now, push it upward from inside to have a teapot shape.

• 

  Step 5

  Like this you will get.

• 

  Step 6

  Apply glue to make it strong.

• 

  Step 7

  Take 15 Strips of length 18.1 cm & 3 mm wide. Make tight coil to fix in lower part of teapot.

• 

  Step 8

  Apply glue on lower edge part of the teapot & fix the tight coil.

• 

  Step 9

  Take 4 strips of length 18.1 cm & width 3 mm.

• 

  Step 10

  Make tight coil & push it upward from inside and glue the inner part.

• 

  Step 11

  This is how it will look.

• 

  Step 12

  Take strip of 10.8 cm length & 3 mm width and roll them.

• 

  Step 13

  Again, make tight coil.

• 

  Step 14

  Apply glue on top part of teapot cover and join the small tight coil.

• 

  Step 15

  Apply glue on top part edge of the teapot for sharp surface. This is done so that the paper will remain in good state.

• 

  Step 16

  Take one strip of length 13.7 cm & width 3 mm. Make tight coil.

• 

  Step 17

  Give a cone shape to it.

• 

  Step 18

  Apply glue on inner part & let it dry.

• 

  Step 19

  Using scissor, cut some part of the cone in slanting position.

• 

  Step 20

  Fix the cone on Teapot.

• 

  Step 21

  For handle:

  Take 2 strips of 3 mm width & measure how much do you need the size of the handle. According to that, fold the strip using glue.
  Make the handle thick.

• 

  Step 22

  Fix the handle on teapot.

• 

  Step 23

  For Cup:

  Take 6 strips of length 18.1 cm & 3 mm wide.
  Make the shape of the cup as done for teapot.

• 

  Step 24

  Make a tight coil using 3 mm width strip & Check whether it fits on lower part of the cup or not. If not, then join extra strips.

• 

  Step 25

  Take 2 mm width strip & make handle for cup. Do as done for teapot.

• 

  Step 26

  For plate:

  Take 8 strips of length 21.1 cm & width 3 mm. Make tight coil & glue only one side.

• 

  Step 27

  Now, paint according to your choice of colours.
  I like dark colours, so I did like this.

Comments

Leave your comment