Valentines Goody Box

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Lay the container on the paper, putting it on the corner end and flipping over until it will cover the circumference of the container. Mark on the paper then cut.

• 

  Step 2

  I used a Blue Bunny Brand container which is made of plastic and narrower at the bottom than it is at the top, so I did end up cutting the paper into two segments and then overlapped on the sides.

• 

  Step 3

  Rub a glue stick on the container (or use craft glue) and glue the paper to the container. I do not recommend using the glue gun as it give a lumpy appearance. I used mylar gift wrap from Dollar Tree, but other themed wrap or scrapbook paper could be used. Glue the paper to the container.

• 

  Step 4

  For the front, I cut out the letters "LOVE" freehand from the mylar, but any different paper from the wrap applied to the container would do. Glue on with glue stick or craft glue.

• 

  Step 5

  For the back I cut out a heart freehand and glued it down with a glue stick.

• 

  Step 6

  For the top, put the paper right side down and put the lid on top of it and trace around it with a marker or pen, then cut out and glue to the top with a glue stick or craft glue.

• 

  Step 7

  Starting at one of the edges on the lid, apply a bit of hot glue on the lid at a time and glue the ribbon around the edge. I used a silver grey ribbon.

• 

  Step 8

  Apply hot glue to the bottom of the the pre-made bow or to make you own, use wire wrapped ribbon and fold over itself into approx. 4 inch long strip, wrap around the center with a string and tie off the pull each piece of the bow out.

• 

  Step 9

  Glue the ribbon to the lid and it is ready to fill with goodies.

Comments

Leave your comment