Recyled Magazine Pot

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Start by ripping out a page from your magazine. Trim the edges if you need to.

• 

  Step 2

  Next start rolling the page up from the corner closest to you, keeping it as tight as you can and not letting it unravel.

• 

  Step 3

  When you get to the end corner, add a drop of the hot glue and wrap the corner round still keeping it nice and tight until it dries, carful not to burn yourself.

• 

  Step 4

  Make as many as you want or measure around the tub your using with a bit of string and the length will be the amount of rolls you need.

  Hope that makes sense.

• 

  Step 5

  This were made with just smaller bits of magazine.

• 

  Step 6

  Gather the tubs or tins you want to decorate.

• 

  Step 7

  Then begin gluing the rolls around the tubs, keeping them inline as possible.

• 

  Step 8

  Trim the bottom and top so it looks like this then repeat the last few steps.. trim them in stages, it'll be much easier.

• 

  Step 9

  It should look like this.

• 

  Step 10

  To make the loops, take a small piece f pipe cleaner and stick one side in one tube, miss one then put the other side in the other. So every other one if that makes sense.. I hope.

• 

  Step 11

  With this, I just trimmed the bottom and left the tops spiky.

  And for the lid on the small round one, I drew round the bottom with cardboard then cut it out and stuck scrap magazine bits around it.

Comments

Leave your comment