Pillar Wrapping

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  If the cylinder has a join somewhere along the vertical, line up the right side of the paper with the join as a starting point.

• 

  Step 2

  Place left side, then right side of paper over cylinder and stick paper together with double-sided tape.

• 

  Step 3

  Bring bottom left edge of paper to center of cylinder to form a tuck. The first tuck should match up with the join of the paper.

• 

  Step 4

  Create tucks at equal intervals.

• 

  Step 5

  To finish, slip edge of paper in under first tuck.

• 

  Step 6

  Create tucks on top edge in the same way, starting at the point where the paper edges join.

• 

  Step 7

  Work tucks at top in the opposite direction from the tucks at the base.

• 

  Step 8

  Be careful not to make lay- ers too thick in the center or to leave a hole.

• 

  Step 9

  To finish, slip edge of paper under first tuck.

• 

  Step 10

  Tip

  The number of tucks
  can be adjusted, but this wrapping looks attractive when opposing tucks form a straight line. Once 1⁄4
  of the cylinder has been wrapped, if there are three tucks, work to create 12 in total; if there are four tucks, create a total of 16.

Comments

Leave your comment