Mr. Bill Ornament

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  For the eyes, you will need two blue caps, for the nose 1 red one and for the mouth a plastic ring off of a milk jug or soda bottle. If you do not have caps/ring in those colors, you can paint them with acrylic paint. I didn't have the a red ring so I painted it red. I also used red paint on the center of the red lid to cover up the wording on the top of the cap.

• 

  Step 2

  For the hair, a few inches from the top of the yellow lid, draw a line across then cut straight across.

• 

  Step 3

  Place the small cut part on the felt, trace around it twice then cut (one will be for the front of the hair, the other for the back. Glue one piece of felt to the front of the plastic. Use the hot glue gun to go around the edges and and affix it to the bottom of the white lid to make the hair.

• 

  Step 4

  To make the face, use the glue gun to separately go around the edge of each bottle cap and then affix to the back of the white lid. If the plastic ring is too large, which mine was, cut it and curl it up into a circle with a dab of hot glue at the end and then on the back and affix to the lid.

• 

  Step 5

  As there was wording on the top of my lid, I used an piece of thick white paper and traced around the lid, cut it out then glued it down with craft glue instead of hot glue to give it smooth surface. Glue the pop tab in the center at the top for the hanger with the hot glue gun.

• 

  Step 6

  Glue the other piece of yellow felt over the top. Thread a ribbon through the top of the tab or use an ornament hanger and it is ready to go the tree.

Comments

Leave your comment

rachel. · U.S. Air Force Academy, Colorado, US · 9 projects 22nd December 2009

hahaa i was exactly going to ask, "who's Mr. Bill?" haha

Reply