Molotow Masking Fluid Marker

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Sketch out your design.
  Draw or use the black transfer paper to trace your drawing onto the watercolour paper.
  Tape down the watercolour paper down onto the Masonite board.

• 

  Step 2

  Use the Molotow Masking Fluid Marker and trace over your entire drawing. Let the masking fluid dry completely, this won't take long at all.
  Paint a few washes of watercolour over your Molotow Masking Fluid drawing on your watercolour paper.
  TIP: ( make sure you have enough water and pigment in your paint brush to do a smooth clean wash in one go).
  Sprinkle a little sea salt on the watercolour paper where you want and it will soak up a bit of the colour leaving less colour behind.

• 

  Step 3

  Wait until the watercolour paper is completely dried.
  After it is completely dried, brush off the sea salt with your finger and rub off the Molotow Masking Fluid with an eraser.
  Enjoy what you created!

Comments

Leave your comment