How To Make An Owl With Polyester Cords

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Get 2 cords in 10cm relatively, fix them with pins. Tie 8 rows of Lark’s head knots.

• 

  Step 2

  Pull the left-most and right-most cords toward the center to tie double half hitches orderly.

• 

  Step 3

  Regard the two cords in the most middle as a holding axis, tie 4 pairs of square knots with the two cords beside the axis. Tie 6 pairs of Lark’s head knots relatively with the most left and most right cords. Roll the square knots in the middle toward upper and thread them down, tie a pair of square again.

• 

  Step 4

  Thread the beads
  Thread the black beads as eyeballs on the 2 yellow cords respectively; pull the 2 cords in the middle toward each side as a holding axis, use the remaining 7 cords to make double half hitches revolve the axis. Repeat the work until there are 5 rows of double half hitches.

• 

  Step 5

  add flosses
  Add one piece of cord in about 40cm long on each side relatively. Pull the added cords on both sides into 2 parts with different size respectively. Treat the short one as the axis; use the long one to make 10 pairs of Lark’s head knots on every side. Cross the 2 cords in the most middle, take the 2 as axises, knit 2 rows of double half hitches in total. There are 6 rows of double half hitches on each side.

• 

  Step 6

  Tie up the two sides with thin cords. Cut off the remaining cords. Add two transparent beads as eyes.

Comments

Leave your comment