About
Upcycle the top off a plastic bottle into a jump ring opening/closing tool
I has purchased jump ring ring tool off of E-Bay and couldn't locate it when I went to work on a project so I decided to DIY my own using the top off of a 20 oz soda bottle.
To use, you put the jump ring in the opening and twist to open. Same thing to close it; put it in the opening and then twist back.
-
Audrey S. favorited Diy Jump Ring Tool
01 Mar 15:16
-
Conner W. added Diy Jump Ring Tool to helping stuff
09 Jul 22:12
-
Conner W. favorited Diy Jump Ring Tool
09 Jul 22:12
-
Shawntay A. favorited Diy Jump Ring Tool
28 Feb 08:38
-
Dawn T. favorited Diy Jump Ring Tool
25 Jun 15:17
You Will Need
-
Step 1Rinse out the bottle and pry off the plastic ring (red on this bottle)
-
Step 2Use a hot knife, or a box cutter the top off of the bottle just above the wider ring before the body of the bottle starts,
-
Step 3Take you time and don't force it as you could cut yourself.
-
Step 4Use the hot knife or box cutter and cut a rectangle between the ridges (I highlighted in red where I cut as it is hard to see.). I cut vertically on each side, then horizontal at the ends.
-
Step 5Use a hot knife or a candle and box cutter to smooth out rough edges.
-
Step 6Use a piece of clear tape to tape over the opening on the inside in case there are any rough edges left so you don't scratch your finger.
Comments
1
Paper Art »
How To Fix A Smoking Toilet
2
Bracelets »
Gifts From The Village Of Shadows Bracelet
3
Charms »
Akuma No Otto Pendant
4
Gadgets »
Kitchen Hook
5
Trays »
Trays For Breakfast
