Diy – Garden Bucket Tool Belt

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Cut the fabric as shown:

• 

  Step 2

  Sew the bias tape on the small pocket first.

  Press 1/4 inch of the sides and bottom of pocket.

  Place the pocket on long piece (Part A), face down with bottom edge 2 inches from the edge and sew.

• 

  Step 3

  Flip over and top stitch sides. Then sew another line of stitching about 1/3 of the way in to make 2 pockets within the pocket.

  Sew bias tape on top of Part A.

• 

  Step 4

  Next pin Parts A and B together lining up the bottom edge with the right sides showing.

  Pin the top corner of Part B sides to match Part A.

  Fold the excess fabric in from the sides at an angle and cut.

  Sew side and bottom edges of Part A to Part B.

  Then sew a line of stitching on both sides of the small pocket from the bottom.

• 

  Step 5

  Then sew the bias tape all along the sides and bottom.

  Repeat with the remaining pieces. (except for the small pocket)

  Then attach the two sections together with the 1 inch cotton twill trim at the top leaving enough space between the two pieces to fit around the handles. I used two rows of stitching for stability.

  Turn in 1 inch of the end of the trim and sew.

  Sew D rings on the other end of the trim and you are finished.

Comments

Leave your comment