About
Glittered Walnut Place Card Holders
Dressing up walnuts and giving them an extra sparkly makeover. When finished they transform into beautiful place card holders, sure to add a lovely touch to your hosted dinner parties and celebrations.
-
Alissa B. favorited Glittered Walnut Place Card Holders 23 Dec 16:54
-
Posh Little Designs published her project Glittered Walnut Place Card Holders 21 Jul 05:26
-
Step 2
(The most difficult part) Take a serrated knife and in a sawing motion, cut into the very top center of the walnut-shell. Hold the walnut sturdy and continue to saw through until there’s about 1/8 – 1 1/6 of an inch slit, deep enough to insert each place card. Please be careful not to cut yourself while completing this step. It helps to curve your fingers down away from the blade of the serrated knife. You could also try using a mini saw, or any other equivalent for the same result.
-
Step 5
Set aside and allow at least 2 hrs to dry (overnight preferred).
Repeat these steps until all walnuts have been covered in as much glitter as your heart desires.
After the walnuts have dried, shake off any loose glitter and begin removing the masking tape. -
Step 6
Now they’re ready for the place cards.
My handwriting skills are not star quality…just being honest, so instead of hand writing the place cards, I simply typed up the names on my desktop and printed them off. This worked like a charm for me and you could do this for your cards as well, but if you happen to have lovely printing, then by all means display the cards with handwritten names.