Pine Cone Skiers

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Get all your tools and materials for the project.

• 

  Step 2

  glue the large bead to the pine cone with pine points pointing down

• 

  Step 3

  paint the bead skin tone

• 

  Step 4

  cut the pop cycle stick in half and paint the two pieces white along with both toothpicks white as well.

• 

  Step 5

  when the toothpicks are dried heat up the glue gun and stick one end of the toothpick into the hot glue then stick a sequin on its end and push it up a bit.

• 

  Step 6

  cut a brown pipe cleaner into four one inch pieces.

• 

  Step 7

  cut a strip of felt about half inch by 6 inches and then cun up the ends to look like a scarf and then starting in the center pull the felt outward till just above the cut ends then pull gently the ends so they apear rayed or a bit uneven.

• 

  Step 8

  cut out the gloves and the boots and attach the pipe cleaners. cut out the hat and glue it and add a yarn ball at end.

• 

  Step 9

  glue the boots to the pop cycle sticks

• 

  Step 10

  tie on the scarf I add some hot glue too

• 

  Step 11

  glue the legs with boots and skies onto the pine cone bottom so they are even

• 

  Step 12

  glue the tooth picks with the sequins on the bottom into the glove so it looks like it is holding it.

• 

  Step 13

  glue the arms onto the pine cone and stand it up

• 

  Step 14

  I used a permanent marker to draw on two eyes and a nose

Comments

Leave your comment