When In Rome Bangle

3D Pen Jewelry

https://www.cutoutandkeep.net/projects/when-in-rome-bangle • Posted by GMC Group

When in Rome, do as the Romans do. This modern design is minimal and sleek and requires fairly little hardware to complete. Trace the numerals in order, or customize with a number that has personal meaning to always keep it with you.

You will need

3D Pen Flexible Filament in a color of your choice Scissors Metallic Paint in a color of your choice 4 Fold-over Cord Ends Four 4mm Jump Rings Two 6mm or 8mm Jump Rings 2 Clasp(s) Pliers

Project Budget

Time

Difficulty

Description

When in Rome, do as the Romans do. This modern design is minimal and sleek and requires fairly little hardware to complete. Trace the numerals in order, or customize with a number that has personal meaning to always keep it with you.

Instructions

1. To Make the Bracelet Measure your wrist, and mark the template at that length; if you need to make the template longer, just repeat the design until you reach your desired length.

2. Using the largest nozzle on your 3D pen, begin extruding the filament—this will give you a running start—and then press the tip of the 3D pen to your template. Trace the first Roman numeral of the bangle, continuing past the ends of the numeral by 1/4 in. (you will trim these later). Repeat for all of the numerals in the template. Inspect each numeral and reinforce as necessary. Without removing the numerals from the template, snip away any excess filament with the scissors, making sure each numeral is the same height.

3. Trace the top band of the bracelet, moving slowly and making sure to overlap the edge of each numeral. Repeat for the bottom edge of the bracelet. Inspect your work and touch up any areas as necessary. Once the filament is completely cooled, gently peel the design from the template and trim away the excess filament with the scissors. If you wish to paint the bracelet in a metallic finish, you may do so now; I used a metallic bronze paint.

4. To make the bracelet as shown, slide a fold-over cord end onto each end of the bracelet. Be sure the flat side of the fold-over cord end is facing upward. On one side of the bracelet, use pliers to attach a 4mm jump ring to each fold-over cord end. On the opposite side, attach a 6mm or 8mm jump ring to each cord end, and then attach a clasp to each of those. To wear, latch the clasps to the corresponding jump rings. Variation You can easily make a headband or choker-style necklace by increasing the template to a length that fits comfortably.