Swirly Wire Bracelet

About

You Will Need (4 things)

Steps (9 steps, 15 minutes)

1. 1

   You don't have to cut wire from the bundle to make this bracelet.
   Hold the wire from any one end from the bundle,
   Leave 3-4 cm of the wire straight and then bend the wire,
   Tighten the bend using the flat nose plier.

2. 2

   Bend the wire again by using the looping plier to create a hook-like pattern.

3. 3

   Now, coil the 1-1.5 cm of the extra straight wire around the longer wire piece.

4. 4

   Create the first loop near the hook by using the looping plier, keep 0.5-1 cm gap between the hook and the loop.
   Circle the wire around that loop 2-3 times to make the first swirl, don't circle the wire more than 3 times otherwise you won't get a smooth round shape for the bracelet.

5. 5

   After completing the first swirl make another loop near it by winding the wire in the opposite direction of the previous loop, keep 1 cm gap between the swirl and the loop,
   Circle the wire around that loop for 2-3 times to make another swirl.
   Keep repeating the steps until you the bracelet reaches its required length.

6. 6

   When you'll think that you've made enough swirls for the bracelet hold it straight with a ruler to check if the size is right.

7. 7

   After measuring the length bracelet cut the wire from the bundle by keeping 3 cm extra on the wire.
   Use the looping plier to create a loop with the extra cms' near the last swirl,
   Coil the remaining wire below the loop.

8. 8

   Wrap the swirl-chain around any round object that matches your hand size and attach both ends together through the hook and loop.

9. 9

   Use the flat nose plier to flatten the swirls,
   Press the swirls against the round object to flatten the swirls and give the bracelet a smooth round shape.

   Done!