Stretchy Watchband
Watch bands should have their own personality just like you do. What kind will yours have?
Posted by Ulysses Press
About
Share
You Will Need (4 things)
- Duct Tape
- Drinking Straw s
- Watch face
- Elastic jewellery Cord
Steps (10 steps, 60 minutes)
-
1
Cut a strip of tape long enough to cover the straw.
-
2
Roll the tape around the straw.
-
3
Cut pieces of wrapped straw the same length as the pin on the watch.
-
4
Cut a strip of tape to the width of the pin and wrap the end around the pin, leaving the adhesive exposed.
-
5
Cut a piece of elastic jewelry cord that is at least 48 inches long and center it against the pin. Note: The length of cord needed may vary based on wrist size and the width of the watch.
-
6
Wrap the tape around the cord and pin to join them.
-
7
Place the ends of the cord through a straw piece in opposite directions and pull the cord tight.
-
8
Continue threading wrapped straw pieces until there are enough to reach halfway around your wrist.
-
9
Temporarily tie off the end and begin the steps on the other side of the watch face.
-
10
Once there are enough pieces to wrap comfortably around your wrist, join them by knotting together the cords and trimming the excess.