Spiral Bound Sticky Note Holder
Sticky Note Holder
Posted by Bedlam & Butterflies
About
Home made spiral bound sticky note holders
Share
You Will Need (12 things)
- Cinch or other Binding Machine
- Wirecutters
- Notebook Spiral
- Card Board
- Watercolor Paper
- Die Cutting Machine
- Dies
- Kraft Paper
- Aqua painter
- Or Paint Brush
- Ink refills
- Palette
Steps (5 steps, 60 minutes)
-
1
Cut 3 pieces of card board and 3 pieces of Kraft paper to 9cm x 10cm.
I save all the card board protectors from packs of designer paper or the backing for paper pads.
-
2
Punch the holes for the notebook spiral using your binding machine along the 9cm side.
For the Cinch I pulled out Notch 7 to prevent getting a hole too close to the right hand edge - you will need to adjust to your own machine. -
3
Stick your sticky notes to two of the three pieces of card board and then cut your notebook spiral to size using wire cutters.
-
4
Attach your spiral to the loading teeth on your binding machine (if there is one) Stack up the 3 card board pieces with the front and back outsides facing each other and the first internal page under the cover page. With the inside back cover on top thread the 3 pieces onto the notebook spiral, then use the closure press on your machine to bring the spiral to meet in the middle.
-
5
Decorate the front cover as desired. I used Watercolour paper and water coloured using an aqua painter and ink refills. Once the back ground was dry I stamped over the top with the same colour ink and added a die cut in the same colour paper.