https://www.cutoutandkeep.net/projects/soap-ducky • Posted by Chicago Review Press
Soap carving is often used as a precursor to carving wood—notably by the Boy Scouts of America, for whom it is a long-established tradition. Soap isn’t really all that similar to wood, but it is cheap and readily available, and it offers a good way to introduce you to handling knives and making some basic cuts. Use a short-blade kitchen knife—the one you’d normally use for cutting vegetables is fine (but the blade should not be serrated). TIP Use straight pins with ball ends for the eyes—but if you use your completed soap ducky in the bathtub, remember to first take out the pins!
Soap carving is often used as a precursor to carving wood—notably by the Boy Scouts of America, for whom it is a long-established tradition. Soap isn’t really all that similar to wood, but it is cheap and readily available, and it offers a good way to introduce you to handling knives and making some basic cuts. Use a short-blade kitchen knife—the one you’d normally use for cutting vegetables is fine (but the blade should not be serrated). TIP Use straight pins with ball ends for the eyes—but if you use your completed soap ducky in the bathtub, remember to first take out the pins!
Your bar of soap should be convex, not concave: a nice fat one is best. You could etch the side profile of the duck onto the soap if you like, but it’s not really necessary.
Establish the back, removing the area behind the head. Start about halfway across the top and cut toward the back, making large paring cuts—or you can do it little by little if you prefer. Cut to about halfway down the bar, scooping out the whole of the corner.
Establish the beak by cutting a curved corner off the top and a larger one off the bottom, leaving a flat piece at the front for the beak. It’s starting to look like a duck already.
Scoop out a small piece from the tail end, curving the knife around as you cut. Leave the rest of the bottom completely flat.
Narrow the head by paring 5 7 off the edges of the soap on both sides. Cut from the back of the head toward the beak, then turn the figure around and cut from the top of the head toward the back—but leave the back itself as wide as possible.
Make a paring cut to round off the back of the head, curving the knife around slightly as 6 8 you cut. Make a V cut at the bottom of the neck to establish a clear division between the back of the head and the body of the duck.
Establish the top of the beak and the front of the head. Cut a “ski slope” from the top of the head down toward the front in a smooth curve. Don’t cut too much off or your duck will be left with no beak.
Create the underside of the beak by cutting down in a curve toward the neck.
se paring cuts to slice off the sharp edges left by previous cuts and to refine the shape of the beak. This is the tricky part, so work slowly and look at the face carefully after each cut to make sure the shape is progressing as you want it.
Round off the remaining edges and tidy up the details, checking for balance and symmetry. Examine your duck from every angle and make small cuts, where necessary, to refine the shape until you’re happy with it.
Carefully insert the pins for the eyes and you’re done.