https://www.cutoutandkeep.net/projects/simple-wire-wrapped-pendant • Posted by Shop Showcase
This tutorial shows you step-by-step how to make a wire "basket" to go around stones, sea glass or shells and make them wearable. I've wrapped four different specimens here so you can see a sample of the possibilities!
This tutorial shows you step-by-step how to make a wire "basket" to go around stones, sea glass or shells and make them wearable. I've wrapped four different specimens here so you can see a sample of the possibilities!
Cut your wire into two equal lengths. Hold them side by side and pinch them with one hand towards the center while using the other hand to twist the wires together about 12 times. (You may need to adjust the amount of twists depending on the size of your specimen.)
Shape the twisted part of the wire to the bottom of your specimen. Holding it there, bring one wire from each side to the front and twist them together twice. Repeat for the back.
Bringing one wire from the front and back, on each side, twist them together twice.
Bringing one wire from each side back to the center, on both the front and back, twist together towards the top until the two twists meet, pulling the wires back together on each set.
Twist the two pairs of wires together until that twist measures about �”. You may want to alter that measurement depending on how big you want your bail to be.
Using your round nose pliers, shape the twist into a loop. This will be your bail.
Holding the bail with your flat nose pliers, use your fingers to wrap the wire ends around the cross section below the bail. Use your wire cutters to clip off the excess wire at the back of the pendant and then tuck in any sharp ends with your flat nose pliers.
Using your round nose pliers, kink any or all of the straight sections of wire on your piece to tighten up the wrap and to also add a decorative touch. Don’t be too rough when doing this because you can weaken the wire. Hang it from a chain or cord and it’s ready to wear:)