Scalloped Hem

Create a fun scalloped hem on just about anything!

Posted by Sarai M.

About

You can use this tutorial to add scallops to almost any hem. Highly customizable, you can make the tiniest scallops, deep scallops, you name it, you got it!

Share

You Will Need (6 things)

  • 1 Pattern Or Finished Garment
  • Paper
  • French Curve
  • Ruler
  • Marking Tool
  • Point Turner

Steps (13 steps, 60 minutes)

  1. 1

    Lengthen your pattern’s hem. You need to extend the hem by taping paper to the pattern. For this hem, I added 1 1/4″.

    Calculate the width of each scallop. Start by measuring the total length of the hem. For this shirt there will be 11 scallops. So divide the total length of the hem by the number of scallops. In this case it is 42″ divided by 11 equals approximately 3 7/8″. Each scallop will be about 3 7/8″ wide.

  2. 2

    Using a large piece of scrap paper, draw a line 3/8 from the edge of the paper. This will be the distance from the top of the hem’s finished edge. Mark along the line every 3 7/8″ (or the width of your scallops).

  3. 3

    Draw a line for the bottom of the scallop. This must be smaller than the hem width (in our case, 1 7/8″). In this case I drew a line 1 3/8″ from the top line.

  4. 4

    Using a French curve or a can, draw your scallops. Cut out the template and put it on the fabric.

  5. 5

    Cut out your pattern and sew it following the directions given. Stop when you reach the hem. Use pinking shears to pink the edge of the hem or serge it as I’ve done here.

  6. 6

    Fold the hem. The hem plus the seam allowance is 1 7/8″. Fold the fabric this width all the way around the garment, right sides together. You’re folding it to the outside. Lightly press the fold to keep it in place.

  7. 7

    Place the template at the top of the hem or a little lower. Trace the outline of the scallops onto the hem with marking tool. If the scallops are a little off, go ahead and sketch them to fit. It’s okay if it’s not perfect!

  8. 8

    Stitch on the lines you've just drawn. Shorten the stitch length to around 1.8. This makes it so much easier to sew those curves. Start and end at each point. Lift the presser foot and adjust the fabric at each point. Repeat until all scallops are finished.

  9. 9

    Trim the seam allowance. Trim close to the edge, about 1/8″.

  10. 10

    Carefully snip to the point between each scallop. Get as close to the stitching line as you can without cutting the thread.

  11. 11

    Flip hem to the inside. The scallops should look a bit disheveled like so.

  12. 12

    Push the scallops out. Using the smooth, curved side of your point turner, push along the inside of each scallop. Move the point turner like a windshield wiper inside the scallop. This has to be done a couple of times to really get the scallop in shape. Press each scallop as you go.

  13. 13

    Hand stitch the hem for a clean finish.