Racerback Fringe Tank

About

You Will Need (4 things)

Steps (8 steps, 35 minutes)

1. 1

   You can free hand a pattern or use one of your favorite tanks as a guide.
   Trace front; flip and trace back. Cut out.

2. 2

   Front back cut outs

3. 3

   Measure length of neck line
   (front only) Shoulder to shoulder.
   a. Note: you can adjust the neck line (shape) to your liking; I made my neckline a little bigger. If you are tracing, do not measure the guide. Measure the fabric cut out neck line.
   b.My new neckline measurements were 20 inches. I wanted the fringe to 9 inches long. So my fabric for the fringe cut out was 25” x 9” (always cut out more than you need just in case, excess can always be trimmed in the end).
   

4. 4

   Measure fabric for neck fringe remember: always measure 3-5 inches more in length just in case. This can always be trimmed later. Cut out.

   3 pieces: front, back and neck line for fringe.

5. 5

   Flip wrong side out and sew sides of tank

6. 6

   Flip right side out and place neck fabric on top of neck line, and then sew together around entire neck line. cut any remaining fabric
   Sew two rows.

7. 7

   Start cutting the neck fabric from bottom to top to create fringes. Do not cut too far up or too close to the thread of the neck line.

8. 8

   When finished cutting all the fringes, Flip wrong side out again and sew tank straps together.