Polo Refashion

Turn an old men's polo shirt into a darling top!

Posted by merrick.white.12

About

When you want a new top and are on a tight budget, dig through your husband or boyfriends closet and find an old polo shirt to make a pretty top for yourself!

Share

You Will Need (2 things)

  • men's (or oversized) Polo Shirt
  • Matching Thread

Steps (13 steps, 120 minutes)

  1. 1

    Cut off the collar. Set it aside to use later.

  2. 2

    Try the shirt on backward (buttons in the back) and mark the new neck hole with pins. Then cut out the neck hole, as shown with the dotted line.

  3. 3

    Since we cut the collar off, go back with a seam ripper and remove the rest of the collar bits, as seen below.

  4. 4

    Go back to the collar piece and open it up, tearing off the interfacing if there is any.

  5. 5

    salvage as long of a strip as possible and iron it flat (as seen with the bottom strip in the photo below).

  6. 6

    now fold it in half, wrong sides together, and press it flat. This will be the "ribbing" for your neckline. If you can't get a long enough piece, just use a few pieces and sew them together.

  7. 7

    attach the ribbing to the neckline with a straight stitch, as seen below.

    The length of my ribbing was about 2 inches shorter than the neck hole, so I pinned it evenly and then pulled the ribbing in between pins as I sewed. This achieved a nice tight neckline. If your ribbing is the same length and isn't pulled tight when sewn, the neckline will be wavy and loose.

  8. 8

    Press the neckline flat and then sew around the neckline with a wide straight stitch just below the ribbing, as shown.

  9. 9

    Fold the raw ends of the ribbing down at an angle and pin, sewing over them to secure them in place as you sew that seam.

  10. 10

    The front of your neckline will now look like this...

  11. 11

    ...and the back will look like this.

  12. 12

    try the shirt on and determine how much you want to take in on the sleeves and the sides. Then lay the shirt flat on the ground and pin in place. Then sew from the sleeve hem to the shirt hem with a straight stitch. Trim the seam allowance and serge or zigzag your raw edge (optional since knits don't fray).

  13. 13

    press all your seams and you're done!