Pinhole Camera

First gather all your supplies. The copper plate/peice of pop can the box or container(cardboard coffee or tea containers work well too) the black electric tape the black paint or card
now make a small hole in the copper plate with the needle. This can take a while, you have to bore into the copper with the needle.
after the hole has been made in the plate tape it to the inside of the box or container, where you want it. now make a hole in the box(infront of the plate hole)
line the inside of the box or container with the black paint or card. It has to be light proof. once completed, put the cover on. Check that no light gets in. make a cover for the outside hole(black tape works fine)
now in a darkroom, place the photographic paper in. Emolsion side facing the hole. The hole is where the light enters(it is like the lense of the pinhole camera) To take a picture, lift the outside flap and keep off for about a minute or so.
Tips. You need plenty of light to make these. The camera should remain still while exposing. Usually wait three to five minutes for a proper exposure. If its inside, with lights, try one to two hours for good exposure.
once the exposure is up, cover the hole tightly with the tape. Bring to the darkroom to develop.
to develop, take the top off the camera(the room has to be light proof) and place the photographic paper in the baths. first in the developer, then the fixer, then the stop bath. hang to dry.
now you have pin hole negitive.