https://www.cutoutandkeep.net/projects/pacman-earrings-2 • Posted by daedalus
Hey Folks, this is the first project I wanted to show. I'm pretty new to handcrafted jewelry but I think it turned out well though. Actually these Earrings are very simple, but some steps are a little bit tricky. I used Fimo polymer clay, flatted it to a thickness of about 1.5mm and cutted the forms out with a sharp knife and a mask. The rest is self explaining. I had some problems with glueing the needle to the backside (6mm plate, 6mm pin), so the next time I will press the plate into the polymer clay befor baking it so there is an appropriate hole. Photos were taken by S.H. www.teleidoscope.de
Hey Folks, this is the first project I wanted to show. I'm pretty new to handcrafted jewelry but I think it turned out well though. Actually these Earrings are very simple, but some steps are a little bit tricky. I used Fimo polymer clay, flatted it to a thickness of about 1.5mm and cutted the forms out with a sharp knife and a mask. The rest is self explaining. I had some problems with glueing the needle to the backside (6mm plate, 6mm pin), so the next time I will press the plate into the polymer clay befor baking it so there is an appropriate hole. Photos were taken by S.H. www.teleidoscope.de