Pacifier Pocket

Pacifier Pocket/ Pouch

Posted by Lola...again!!!

About

I had a couple of babies that LOVED their paci! We had to have several on hand at all times. I remember frantically digging through the diaper bag looking for the elusive Binky, finally finding one stuck to the bottom of the bag, covered in crumbs and gunk! I wish I'd had one of these back then!!
This is a little Pacifier pocket that will hold several pacifiers. It is lined with vinyl (fused) fabric! This is a simple project that only took a few minutes to whip up!
My lables were designed and made by MommyMadeIt on etsy! Cute and great prices too!

Share

You Will Need (6 things)

  • Fabric
  • Vinyl
  • Velcro
  • Pin(s)
  • Iron
  • Sewing Machine

Steps (11 steps, 120 minutes)

  1. 1

    Make a paper pattern. One piece is 4" x 6". The other is 7" x 4 ", taper the top of this one however you would like.

    From outside fabric, lining fabric, and iron on vinyl cut 1 of each pattern piece.

  2. 2

    remove vinyl from backing and place on the right side of your fabric.

  3. 3

    place the paper, that you just peeled off the vinyl, shiny side down on top of the vinyl. Press with Iron set on Wool setting. It only takes a few seconds to fuse.

  4. 4

    allow it to cool, and peel the paper off. Repeat with other lining piece.

  5. 5

    Sew a 1" piece of Velcro about 1/2" down from the top of long piece. Sew lining together.

  6. 6

    Cut a one inch square out of each corner.

  7. 7

    Fold so side seam matches up with bottom seam and stitch across at 1/4".

  8. 8

    Sew the outside together the same way that you did the lining. Sew the other half of the Velcro on the front, about 1/2" down from the edge.

  9. 9

    Put lining inside of outer bag- wrong sides together.

  10. 10

    Fold the top edges in 1/4"- 1/2", pin in place, then carefully stitch around the edge.

  11. 11

    Your Paci bag is finished!! Embellish it with whatever you want, or leave it plain!